System Defaulted

Was bedeutet 48 ?

The drive received a command to write its factory default values, resulting in a reset of all configured parameters. This fault indicates that the drive requires a complete re-commissioning. All application-specific settings have been lost and must be re-entered to ensure correct drive operation and prevent unintended behavior.

• Accidental initiation of the 'Factory Default' command via the drive's Human Machine Interface (HMI) or a connected control system (e.g., setting Parameter P1-11 to '1').
• Firmware update process included an unacknowledged or mandatory step to reset all parameters, leading to a loss of configuration.
• Loss of non-volatile memory integrity within the drive (e.g., EEPROM, Flash), causing a forced reset to default settings upon power-up.
• Faulty HMI button or an intermittent external digital input inadvertently activating the default command.
• Corruption of the parameter storage area during an unexpected power cycle, brownout event, or high EMI transient, leading to a fallback to defaults.

Klicken Sie auf Schritte, um Ihren Fortschritt zu verfolgen.

1. 1

   1. Access the drive's HMI or commissioning software and verify the current parameter values by cross-referencing with the last known configuration backup (e.g., Parameter P0-01 for motor rated voltage).

2. 2

   2. Locate the most recent valid backup file of the drive's configuration parameters on the commissioning PC or network share.

3. 3

   3. Load the saved parameter configuration file into the drive using the appropriate software tool or by manual entry via the HMI.

4. 4

   4. Cycle power to the drive and observe the fault status on the HMI to confirm the re-commissioning was successful and no new faults appear.

5. 5

   5. Test motor operation at a low speed reference (e.g., 5 Hz) and monitor actual motor current (A) and speed (RPM) to verify basic functionality according to the loaded parameters.