Error when checking diagnostic output signal

Was bedeutet F3132 ?

This non-fatal safety error indicates an issue during the internal validation of diagnostic output signals by the IndraDrive MPx02's safety control. This means the drive's self-diagnosis of its safety outputs has detected an inconsistency, potentially affecting the reliability of safety-related outputs.

• Internal hardware fault within the safety module responsible for diagnostic outputs.
• Discrepancy between the commanded state and the actual feedback of a diagnostic output.
• Firmware issues affecting the diagnostic routines of safety outputs.
• Electromagnetic interference causing transient errors in internal signal monitoring.

Klicken Sie auf Schritte, um Ihren Fortschritt zu verfolgen.

1. 1

   Perform a power cycle of the IndraDrive MPx02 to reset the safety logic and internal diagnostic systems.

2. 2

   Verify the integrity of the drive's firmware and update it if a newer, more stable version is available.

3. 3

   Check for any external connections or loads on diagnostic outputs that might be causing an unexpected feedback condition.

4. 4

   Inspect the control section of the IndraDrive MPx02 for any visible signs of damage or loose components.

5. 5

   If the fault persists after these steps, it may indicate an internal hardware defect requiring service by Bosch Rexroth.