Warning invert rotation

Was bedeutet 25232 ?

This warning occurs when a negative setpoint is selected with an active limitation of rotation (parameter 0x283A (P304.00)), or if the 'Reverse rotational direction' function (parameter 0x2631:013 (P400.13)) is requested while rotation limitation (parameter 0x283A (P304.00)) is active. The motor will be brought to a standstill because reversal of the rotating direction is not permissible under these conditions.

• A negative speed setpoint is commanded while the drive's rotational direction is explicitly limited by Parameter 0x283A (P304.00).
• The 'Reverse rotational direction' function (Parameter 0x2631:013) is active, conflicting with a commanded forward setpoint or a rotation limit.
• Inconsistent drive configuration where a unidirectional operation limit is enabled but a bidirectional speed command source is active.
• External control system (e.g., PLC) sending a negative speed command inadvertently, conflicting with drive settings.
• Incorrect value set in Parameter 0x283A (P304.00) restricting desired bidirectional motor operation.

Klicken Sie auf Schritte, um Ihren Fortschritt zu verfolgen.

1. 1

   Verify the current speed setpoint (e.g., via HMI, fieldbus monitor) and its polarity (e.g., -100 RPM).

2. 2

   Examine Parameter 0x283A (P304.00) to confirm if a rotation limitation (e.g., 'Forward Only') is enabled.

3. 3

   Check the state of the 'Reverse rotational direction' function (Parameter 0x2631:013) to see if it is active.

4. 4

   Adjust the speed setpoint to be positive if unidirectional forward rotation is intended, or disable the rotation limitation in Parameter 0x283A (P304.00).

5. 5

   Review the PLC or master control program to ensure speed commands and direction signals are consistent with the drive's desired operation mode.