Parameter storage device fault (control circuit board)

Was bedeutet E.PE ?

This fault indicates an error with the inverter's internal parameter storage device (EEPROM) on the control circuit board. This can be caused by a corrupted memory block or by an excessive number of parameter write cycles, which can wear out the EEPROM. A corrupted EEPROM can lead to incorrect operation, loss of critical configuration data, or complete inverter malfunction.

• Data corruption within the inverter's EEPROM memory due to power fluctuations, EMI, or transient voltage spikes.
• Exceeding the specified write endurance cycles of the EEPROM, leading to wear-out and inability to store data reliably.
• Internal hardware malfunction of the EEPROM chip or its interface circuitry on the control board.
• Incorrect firmware update process or an interrupted update causing incomplete or corrupted parameter storage.
• Long-term exposure to harsh environmental conditions (temperature, humidity) affecting the control board components.

Klicken Sie auf Schritte, um Ihren Fortschritt zu verfolgen.

1. 1

   Perform a parameter initialization (clear all parameters to factory defaults, e.g., Pr. 160 = 1 or Pr. 77 = 1) and then re-enter essential parameters carefully.

2. 2

   Power cycle the inverter completely (remove main power supply R/L1, S/L2, T/L3 for 5 minutes) to reset the control board and internal memory.

3. 3

   Back up all current parameter settings (if accessible) before attempting a reset, using a Parameter Unit or software tool.

4. 4

   Check the input power stability and grounding of the inverter to mitigate potential EMI or power fluctuations that could affect EEPROM integrity.

5. 5

   If the fault persists after initialization, consider replacing the control circuit board as the EEPROM or its associated hardware may be faulty.