Remote Controller Transmission Error

Was bedeutet E3 ?

The remote controller cannot find a blank transmission path for 6 seconds and cannot transmit, or the indoor controller board cannot find a blank transmission path. This can be due to multiple remote controllers set as 'main', a remote controller connected to multiple indoor units, repeated refrigerant addresses, a defective transmitting/receiving circuit on the remote controller or indoor controller board, or noise in the remote controller transmission wire.

• Remote controller fails to transmit commands to the indoor unit.
• Damaged or disconnected wiring between remote controller and indoor unit.
• Faulty remote controller.
• Faulty indoor unit communication interface.

Klicken Sie auf Schritte, um Ihren Fortschritt zu verfolgen.

1. 1

   Set one remote controller to 'main' and any others to 'sub'.

2. 2

   Ensure the remote controller is connected with only one indoor unit.

3. 3

   Change the refrigerant address to a separate setting.

4. 4

   Diagnose the remote controller: If 'RC OK' is displayed, turn power off/on; if abnormal again, replace indoor controller board. If 'RC NG' is displayed, replace the remote controller. If 'RC E3' or 'ERC 00-66' is displayed, noise may be the cause.