GOCFG process failed

Was bedeutet F59 ?

This Manual Fault indicates that the auto-configuration process has failed, meaning the unit was unable to correctly configure itself automatically. This typically requires manual intervention to set up the system.

• Incompatible or missing external hardware components required for the auto-configuration sequence (e.g., sensor not connected, expansion module not detected).
• Corrupted or outdated firmware that contains errors in the auto-configuration routine.
• Power supply instability or interruptions during the critical configuration phase.
• Conflicting network addresses or device IDs when attempting multi-device auto-configuration.
• Incorrect initial parameter settings (e.g., P0-01 'Device Mode' set incorrectly) preventing the automatic process from starting.

Klicken Sie auf Schritte, um Ihren Fortschritt zu verfolgen.

1. 1

   1. Verify all necessary external hardware (e.g., communication modules, sensors) are properly connected and powered, checking individual connection terminals (e.g., X1, X2).

2. 2

   2. Perform a factory reset of the device parameters (e.g., using button combination or menu option 'System -> Reset Defaults') to clear any conflicting settings.

3. 3

   3. Manually enter the required configuration parameters (e.g., P1-01 'Motor Type', P1-02 'Rated Voltage') via the HMI or configuration software, bypassing auto-config.

4. 4

   4. Update the device's firmware to the latest stable version, which may include fixes for the auto-configuration process.

5. 5

   5. Check the device log for specific sub-codes or messages related to the GOCFG failure that can indicate the exact point of error.