ASIC Version Fault

Was bedeutet CPF10 ?

An ASIC Version Fault was detected, indicating an issue with the ASIC's version identification or integrity. This points to control circuit damage, compromising the drive's fundamental operation.

• ASIC chip's internal version register corrupted or unreadable due to hardware defect.
• Mismatch between the expected ASIC version (by firmware) and the detected version (e.g., wrong control board replacement).
• Internal ASIC hardware failure preventing correct identification during boot-up.
• Firmware corruption on the main control board leading to an incorrect ASIC version check routine.

Klicken Sie auf Schritte, um Ihren Fortschritt zu verfolgen.

1. 1

   1. Perform a complete power cycle of the drive, ensuring a cold boot and full system re-initialization.

2. 2

   2. Verify that the control board assembly part number matches the drive's specified Bill of Material (BOM) for compatibility.

3. 3

   3. Attempt a full parameter reset (e.g., Parameter P0-03=2) to clear potential software integrity issues.

4. 4

   4. Visually inspect the control board for any signs of physical damage that might affect component identification.

5. 5

   5. If the fault persists, replacement of the control board is necessary as the ASIC is a critical, integrated component.