EL
ErrorLib
Brands
||
  1. Home
  2. ABB
  3. PB610 Panel Builder 600 Programming Software
  4. 2
About·Privacy·Terms

ErrorLib — Industrial Fault Code Library

Disclaimer: ErrorLib is an independent technical reference tool. While we aim for accuracy, always verify with the manufacturer’s official service manuals before performing maintenance on industrial equipment. ErrorLib is not affiliated with the brands listed.

2

Safety Source Address Not Valid (V2 CPU)

ABB · PB610 Panel Builder 600 Programming Software

What does 2 mean?

The safety source address (F_Source_Add) is not valid in an AC500 V2 non-safety CPU PM5xx system. This indicates an incorrect configuration of the source address for PROFIsafe communication.

Common Causes

  • Safety control system cannot find the configured source PLC address.
  • Network communication issue from the source safety device.
  • Incorrect safety address configured in the V2 CPU parameters.
  • Source safety device is offline or not powered.

Repair Steps & Checklist

Click steps to track your progress.

  1. 1

    Check the safety PLC configuration for the "F_Source_Add" parameter.

Browse all codes in this manual (58)
Verified technical data. Last updated: April 2026

Related Faults

1Safety Destination Address Not Valid (V2 CPU)10Parameter F_SIL Exceeds Specific Application SIL (V2 CPU)11Safety Watchdog Time Zero (V2 CPU)
Source: ABB PB610 Panel Builder 600 Programming Software
Open Manual (Page 434)Search more codes in this manual