No block-transfer response (timeout)

What does 00D0 mean?

The scanner did not receive a block-transfer response from the block-transfer module within 3.5 seconds of the request. This indicates a communication timeout, resulting in an unknown error.

• The scanner did not receive a block-transfer response from the block-transfer module within 3.5 seconds of the request

Click steps to track your progress.

1. 1

   Inspect all communication cabling between the Logix 5000 controller's scanner module and the block-transfer module for damage, proper routing, and secure connections at both ends.

2. 2

   Verify the power supply to the block-transfer module by checking its status LEDs and measuring the input voltage at its terminals against the specified range.

3. 3

   Check the status indicator LEDs on the block-transfer module for any fault indications or communication activity, and verify its network configuration settings (e.g., IP address, subnet mask) if applicable.

4. 4

   Review the Logix 5000 controller's I/O configuration for the block-transfer module, ensuring correct module type, revision, and communication parameters (e.g., RPI, connection type) are configured.