EL
ErrorLib
Brands
||
  1. Home
  2. Bosch Rexroth
  3. Motion Control
  4. 1333
About·Privacy·Terms

ErrorLib — Industrial Fault Code Library

Disclaimer: ErrorLib is an independent technical reference tool. While we aim for accuracy, always verify with the manufacturer’s official service manuals before performing maintenance on industrial equipment. ErrorLib is not affiliated with the brands listed.

1333

The PLC program is in STOP state because of switch position '1' on the SM-module.

Bosch Rexroth · Motion Control

What does 1333 mean?

The PLC user program is prevented from starting because the physical switch on the SM module is currently set to position '1'. This is a PLC error that requires a change in the module's switch setting or a software override.

Common Causes

  • SM module switch set to position '1', preventing PLC program startup.

Repair Steps & Checklist

Click steps to track your progress.

  1. 1

    Change the switch on the NC module to another position (e.g., '0') and initiate a new system startup.

  2. 2

    Alternatively, switch the PLC program to 'RUN' using the programming device monitor.

Browse all codes in this manual (60)
Verified technical data. Last updated: April 2026

Related Faults

1287Error during generating the stack for the IdleTask.1288SERCOS state class 1: Overload cut-off %s-axis.1289SERCOS state class 1: Amplifier overtemperature cut-off %s-axis.
Source: Bosch Rexroth Motion Control
Open Manual (Page 82)Search more codes in this manual