EL
ErrorLib
Brands
||
  1. Home
  2. Bosch Rexroth
  3. Motion Control
  4. 826
About·Privacy·Terms

ErrorLib — Industrial Fault Code Library

Disclaimer: ErrorLib is an independent technical reference tool. While we aim for accuracy, always verify with the manufacturer’s official service manuals before performing maintenance on industrial equipment. ErrorLib is not affiliated with the brands listed.

826

Subprogram %s does not exist (covers 826-827).

Bosch Rexroth · Motion Control

What does 826 mean?

A programming error was detected at a CPL command because the specified subprogram '%s' does not exist. This fault, covering codes 826 to 827, indicates an issue within the part program's structure or dependencies.

Common Causes

  • Programming error at CPL command, indicating a non-existent subprogram.

Repair Steps & Checklist

Click steps to track your progress.

  1. 1

    Refer to 'CPL Programming Instructions' for further guidance on programming errors.

  2. 2

    Correct the programming error related to the missing subprogram.

  3. 3

    Select the part program again and restart it if necessary after correction.

Browse all codes in this manual (60)
Verified technical data. Last updated: April 2026

Related Faults

1287Error during generating the stack for the IdleTask.1288SERCOS state class 1: Overload cut-off %s-axis.1289SERCOS state class 1: Amplifier overtemperature cut-off %s-axis.
Source: Bosch Rexroth Motion Control
Open Manual (Page 60)Search more codes in this manual