EL
ErrorLib
Brands
||
  1. Home
  2. Kone
  3. V3F25/18 drive
  4. 0117
About·Privacy·Terms

ErrorLib — Industrial Fault Code Library

Disclaimer: ErrorLib is an independent technical reference tool. While we aim for accuracy, always verify with the manufacturer’s official service manuals before performing maintenance on industrial equipment. ErrorLib is not affiliated with the brands listed.

0117

Shaft setup not done

Kone · V3F25/18 drive

What does 0117 mean?

The V3F25/18 drive will not run in normal drive mode; only RDF (machine room inspection drive in North America) and inspection drives are possible. This fault indicates that the initial shaft setup procedure has not been completed.

Common Causes

  • Shaft setup procedure has not been performed.

Repair Steps & Checklist

Click steps to track your progress.

  1. 1

    Perform the shaft setup procedure.

Browse all codes in this manual (20)
Verified technical data. Last updated: April 2026

Related Faults

0101Drive stop0102Motor overcurrent0103Damaged Braking resistor or electrical circuits
Source: Kone V3F25/18 drive
Open Manual (Page 40)Search more codes in this manual