EL
ErrorLib
Brands
||
  1. Home
  2. SEW Eurodrive
  3. MOVI-PLC SyncCrane Application
  4. FF0201h
About·Privacy·Terms

ErrorLib — Industrial Fault Code Library

Disclaimer: ErrorLib is an independent technical reference tool. While we aim for accuracy, always verify with the manufacturer’s official service manuals before performing maintenance on industrial equipment. ErrorLib is not affiliated with the brands listed.

FF0201h

Invalid Number of Axes

SEW Eurodrive · MOVI-PLC SyncCrane Application

What does FF0201h mean?

This fault indicates that the SyncCrane application solution has been configured with an invalid number of axes. The system explicitly supports a maximum of 8 axes for control. Selecting more than 8 axes will trigger this error.

Common Causes

  • The number of configured axes for the motion controller is invalid.
  • Configuration error in the axis mapping or count.
  • Software limit on the maximum number of supported axes has been exceeded.

Repair Steps & Checklist

Click steps to track your progress.

  1. 1

    Verify that the configured number of axes in the MOVI-PLC® SyncCrane application solution does not exceed 8.

Browse all codes in this manual (9)
Verified technical data. Last updated: April 2026

Related Faults

F29Hardware Limit Switch ApproachedFF0202hInvalid Axis SelectionFF0203hSoftware Limit Switch CW Exceeded
Source: SEW Eurodrive MOVI-PLC SyncCrane Application
Open Manual (Page 86)Search more codes in this manual