PROFIsafe Watchdog Timed Out

¿Qué significa 16153 ?

The PROFIsafe watchdog timer has expired, meaning the safety I/O module did not receive a valid PROFIsafe telegram within the expected timeframe. This indicates a communication interruption or delay that prevents the safety system from functioning correctly, leading to a safe state.

• Severe communication interruption or loss of connection between the safety CPU and the safety I/O module.
• The PROFIsafe watchdog timer parameter (F_WD_Time) in the configuration is set too short for the actual network update rate.
• High network load or latency causing delays in PROFIsafe telegrams, exceeding the watchdog period.
• Intermittent fault in the PROFIBUS/PROFINET infrastructure (e.g., faulty switch port, damaged coupler).
• Internal communication processor failure within the safety I/O module.

Haga clic en los pasos para seguir su progreso.

1. 1

   1. Check the network status LEDs on both the safety CPU and the safety I/O module for communication errors or link failures.

2. 2

   2. Verify the physical PROFIBUS/PROFINET connection and check for loose cables or damaged connectors.

3. 3

   3. Review and potentially increase the F_WD_Time parameter in the safety configuration to allow for network variations.

4. 4

   4. Monitor the network traffic and bus cycle time using a network analyzer to identify excessive delays or telegram loss.

5. 5

   5. If all communication path components are verified, perform a firmware update on the safety I/O module or replace the module.