Drive Into Positive Stop Procedure Command Error

¿Qué significa 260 ?

This error indicates a problem during the execution of the procedure command 'Drive Into Positive Stop' (IDN S-0-0149), causing the DDS 2.1 drive to shut down. This prevents the drive from performing its commanded controlled stop function.

• Incorrect configuration or parameters related to the 'Drive Into Positive Stop' command (IDN S-0-0149).
• Mechanical obstruction preventing the drive from reaching the positive stop.
• Fault in the drive's internal logic or hardware when processing the command.
• Safety limits (e.g., overtravel limit switches) being triggered unexpectedly.

Haga clic en los pasos para seguir su progreso.

1. 1

   Review the parameters associated with the 'Drive Into Positive Stop' command (IDN S-0-0149) and the application's mechanical limits to ensure they are correctly configured.

2. 2

   Inspect the mechanical system for any physical obstructions, binding, or damage that could prevent the motor from moving to the positive stop.

3. 3

   Verify the operation of any limit switches or external sensors associated with the positive stop function.

4. 4

   Check the drive's diagnostic history for any other related faults that may have occurred simultaneously.

5. 5

   If the issue persists and no external cause is found, contact Indramat technical support for further diagnosis of the DDS 2.1 drive's internal state.