Analog input select

¿Qué significa 50 ?

This fault indicates that the current at an analogue input (configured for a 4-20mA range) is below 4mA, or the voltage at an analogue input (configured for a 2-10V range) is below 2V. This typically points to a broken or loose control cable or a failure of the signal source device.

• Motor current exceeds the drive's maximum allowed limit (e.g., P0200).
• Short circuit in motor windings or output cables.
• Mechanical overload on the motor shaft.
• Rapid acceleration/deceleration causing current surge.
• Incorrect motor data entered into drive parameters.

Haga clic en los pasos para seguir su progreso.

1. 1

   Check the entire current or voltage loop circuitry, including the signal source, control cables, and input terminals (e.g., AI1, AI2, GND) for proper connection and continuity.