Single Phase Overload

¿Qué significa 33 ?

This fault occurs when the drive is configured for single-phase operation (parameter 517), and the DC bus voltage ripple exceeds the drive's allowable limits. This indicates the input power demand is too high for the drive's capacity in single-phase mode. This can lead to drive instability and potential damage if overloaded.

• Drive operating in single-phase mode (P5-17 = 1) with an output load current exceeding the drive's derated capacity for single-phase input.
• Input line impedance too high for the single-phase supply, causing excessive voltage drop and increased DC bus ripple under load.
• Failure of internal DC bus capacitors, reducing their filtering capacity and increasing ripple voltage.
• Unbalanced loading on the single-phase input leading to high RMS current draw on the active phases.

Haga clic en los pasos para seguir su progreso.

1. 1

   1. Verify Parameter P5-17 (Input Phase Configuration) is correctly set to '1' for single-phase operation.

2. 2

   2. Reduce the motor load or operating current (monitor P0-01) to stay within the drive's derated current capacity for single-phase input.

3. 3

   3. Check input voltage stability at L1 and L2 (or L1 and L3) terminals under load using a true RMS multimeter, ensuring it remains within specified limits.

4. 4

   4. Ensure input power wiring gauge is adequate for the current draw, minimizing voltage drop to the drive.

5. 5

   5. If supported, consider adding an input line reactor to reduce input current harmonics and DC bus ripple.