Oversetter...
2

Safety Source Address Not Valid (V2 CPU)

ABB · PB610 Panel Builder 600 Programming Software

Hva betyr 2 ?

The safety source address (F_Source_Add) is not valid in an AC500 V2 non-safety CPU PM5xx system. This indicates an incorrect configuration of the source address for PROFIsafe communication.

Vanlige årsaker

  • Safety control system cannot find the configured source PLC address.
  • Network communication issue from the source safety device.
  • Incorrect safety address configured in the V2 CPU parameters.
  • Source safety device is offline or not powered.

Reparasjonssteg & Sjekkliste

Klikk på steg for å spore fremgangen.

  1. 1

    Check the safety PLC configuration for the "F_Source_Add" parameter.

Se alle koder i denne manualen (58)
Verifisert teknisk data. Sist oppdatert: March 2026

Relaterte feilkoder

1Safety Destination Address Not Valid (V2 CPU)10Parameter F_SIL Exceeds Specific Application SIL (V2 CPU)11Safety Watchdog Time Zero (V2 CPU)
Kilde: ABB PB610 Panel Builder 600 Programming Software
Open Manual (Page 434)Søk flere koder i denne manualen