Oversetter...
28674

F-device Invalid Safety Source Address (V3 CPU)

ABB · PB610 Panel Builder 600 Programming Software

Hva betyr 28674 ?

The safety source address (F_Source_Add) for F-device instance <n> in an AC500 V3 non-safety CPU PM56xx system is not valid. This indicates an incorrect configuration of the source address for PROFIsafe communication.

Vanlige årsaker

  • The F-device's safety source address is invalid or not configured correctly.
  • Incorrect assignment of safety source addresses within the PROFIsafe network configuration.
  • Missing or unassigned safety source address.

Reparasjonssteg & Sjekkliste

Klikk på steg for å spore fremgangen.

  1. 1

    Check the Safety PLC configuration for F-device instance <n> and the "F_Source_Add" parameter.

Se alle koder i denne manualen (58)
Verifisert teknisk data. Sist oppdatert: March 2026

Relaterte feilkoder

1Safety Destination Address Not Valid (V2 CPU)10Parameter F_SIL Exceeds Specific Application SIL (V2 CPU)11Safety Watchdog Time Zero (V2 CPU)
Kilde: ABB PB610 Panel Builder 600 Programming Software
Open Manual (Page 459)Søk flere koder i denne manualen