Oversetter...
1301

SERCOS state class 1: Position limit of %s-axis exceeded.

Bosch Rexroth · Motion Control

Hva betyr 1301 ?

This SERCOS state class 1 error indicates that the physical or software-defined position limit of the specified axis has been exceeded. The drive attempts the best possible response with a subsequent torque release. This fault suggests a runaway condition, incorrect limit settings, or a control issue.

Vanlige årsaker

  • Servo loop fault
  • Drive fault
  • Position limit exceeded on the %s-axis.

Reparasjonssteg & Sjekkliste

Klikk på steg for å spore fremgangen.

  1. 1

    Initiate a control reset in the active channel.

Se alle koder i denne manualen (60)
Verifisert teknisk data. Sist oppdatert: March 2026

Relaterte feilkoder

1287Error during generating the stack for the IdleTask.1288SERCOS state class 1: Overload cut-off %s-axis.1289SERCOS state class 1: Amplifier overtemperature cut-off %s-axis.
Kilde: Bosch Rexroth Motion Control
Open Manual (Page 80)Søk flere koder i denne manualen