No Machining Cycle Found (Figure Block Only)

Hva betyr 3510 ?

This MC alarm (specific to Series 30i) indicates that the control system could not find a valid machining cycle to execute. This occurs when the machining program specifies only a figure block without the necessary accompanying machining type block, making the intended operation undefined.

• A defined machining shape is present, but no active cutting command follows.
• The program structure lacks the necessary commands for material removal.
• Only geometric data (e.g., G02, G03) was found without a cutting feed (e.g., G01).
• The controller requires a specific block type for machining initiation.

Klikk på steg for å spore fremgangen.

1. 1

   Modify the machining program by adding the required machining type block to define the intended machining cycle.