SH2 status test to active

Hva betyr 10592 E010 ?

The measured status of the '-SH2' signal is at a 'high' level and fails to change to the 'active' ('low' level) status, despite the CC (Controller Control) no longer triggering its corresponding watchdog. This indicates an internal software error or hardware defect.

• The measured status of the "-SH2" signal is "high" level.
• The "-SH2" signal does not change to the "active" ("low" level) status, although the CC is no longer triggering the corresponding watchdog.
• Internal software error.
• Hardware defective.

Klikk på steg for å spore fremgangen.

1. 1

   Power cycle the NC control and related CC modules to reset the system and clear transient software errors.

2. 2

   Inspect the wiring and connections of the -SH2 signal path, particularly where it interfaces with the CC unit, for damage or loose terminals.

3. 3

   Check the CC module for any visible signs of damage, overheating, or component failure.

4. 4

   Verify the safety software configuration related to the -SH2 signal and its interaction with the CC watchdog.

5. 5

   If possible, use a multimeter or oscilloscope to monitor the -SH2 signal level during startup and operation to identify its state transitions.