Not ready for power on

Hva betyr E2829 ?

The IndraDrive MPx02 is in a state where it cannot be powered on, meaning its internal power section cannot be enabled. This typically implies that a critical prerequisite or safety condition required before activating the power output stages has not been met, preventing motor control.

• A pending error or warning that prevents power-on. These must be cleared first.
• Safety circuit not closed or active, inhibiting the power-on sequence.
• Internal hardware fault preventing power section readiness after self-tests.
• Missing or incorrect drive parameterization required for the initial power-on state.
• DC bus not charged to a stable and sufficient level.

Klikk på steg for å spore fremgangen.

1. 1

   Review the drive's diagnostic messages and display for any other active errors or warnings that are inhibiting the "power on" state. Resolve these first.

2. 2

   Verify that all external safety circuits (e.g., STO, SS1, E-stop) are closed and properly reset, allowing the drive's power section to be enabled.

3. 3

   Check the DC bus voltage to ensure it has charged to a stable and sufficient level required for power-on.

4. 4

   Ensure that the drive enable command from the master controller is not active prematurely or is not being correctly interpreted by the drive's logic.

5. 5

   Perform a full power cycle of the IndraDrive MPx02 if no other issues are immediately apparent, then attempt to power on again.