Oversetter...
CheckMedia- Control
Check media control!
Kuka · LaserTech 3.1
Hva betyr CheckMedia- Control ?
An error related to media control (e.g., process gas, cooling water, compressed air) has occurred. This issue needs to be resolved before the process can continue.
Vanlige årsaker
- Missing or incorrect media supply to control system.
- Control system failure due to improper media.
- Incorrect media type detected by control.
- Insufficient media flow rate.
- Media contamination affecting control operation.
Reparasjonssteg & Sjekkliste
Klikk på steg for å spore fremgangen.
- 1
Identify and resolve the specific media error (e.g., verify gas pressure, check water flow, inspect media lines).
- 2
Acknowledge the message on the robot controller HMI.
- 3
Resume or restart the active program.
Verifisert teknisk data. Sist oppdatert: March 2026
Relaterte feilkoder
AcknWfdHeat- MessagePlease acknowledge errors on the wire heater unitCollectionErro- rOfLaserError of laser system ---> Resumption of process possible after dialog and forced reset of laserCompleteCold- RunComplete program will be continued without active process. Resumption with active process by executing LASER_INIT command
Kilde: Kuka LaserTech 3.1