Brake control defective

Hva betyr F01630 ?

The motor holding brake control is malfunctioning, posing a risk of uncontrolled motor movement. This can stem from an incorrect p1278 setting, disconnected or interrupted brake cables, a ground fault, or a short-circuit in the brake winding. A fault in the Safe Brake Relay, Control Unit, or Power Module could also be the cause.

• Incorrect setting of parameter P1278 (Brake control mode) for the specific motor or application.
• Interruption or disconnection of the motor brake control cables (e.g., terminals X11/X12 or specific brake module connections).
• Ground fault in the motor brake winding or its supply cabling.
• Failure of the internal brake control relay or solid-state switch within the drive module.
• Overcurrent or short circuit detected in the brake power supply circuit.

Klikk på steg for å spore fremgangen.

1. 1

   Verify the setting of parameter P1278 (Brake control mode) according to the motor's technical specifications and the application's requirements.

2. 2

   Measure the resistance of the motor brake coil directly at the drive's brake terminals (e.g., X11/X12) to compare with the specified value (e.g., 20-50 Ohms).

3. 3

   Check for 24VDC or 400VAC (depending on brake type) output voltage at the brake terminals when the drive commands brake release (e.g., using a multimeter).

4. 4

   Inspect the entire brake cabling path from the drive to the motor for signs of physical damage, loose connections, or insulation breakdown.

5. 5

   Perform an insulation resistance test (Megger test) on the brake cables and motor brake coil to detect ground faults.