Oversetter...
I/O-LED 1-3

EEPROM checksum fault (Fault code 1, argument 3)

Wago · Modular I/O System PROFIBUS DP

Hva betyr I/O-LED 1-3 ?

A checksum error has been detected in the EEPROM (Electrically Erasable Programmable Read-Only Memory) of the Fieldbus Coupler. This indicates data corruption in the non-volatile memory where crucial configuration or firmware data is stored, likely due to a hardware defect in the EEPROM component.

Vanlige årsaker

  • Corrupted data in the coupler's EEPROM
  • Hardware defect of the EEPROM component itself

Reparasjonssteg & Sjekkliste

Klikk på steg for å spore fremgangen.

  1. 1

    Replace the Coupler.

Se alle koder i denne manualen (21)
Verifisert teknisk data. Sist oppdatert: March 2026

Relaterte feilkoder

BUS-LED 1-1Insufficient configuration data (Fault code 1, argument 1)BUS-LED 1-2Excessive configuration data (Fault code 1, argument 2)BUS-LED 2-nFaulty configuration byte n (Fault code 2, argument n)
Kilde: Wago Modular I/O System PROFIBUS DP
Open Manual (Page 100)Søk flere koder i denne manualen