Changed I/O module configuration found after AUTORESET (Fault code 1, argument 6)

Hva betyr I/O-LED 1-6 ?

The Fieldbus Coupler detected a discrepancy between its configured I/O module arrangement and the physically connected modules immediately after an AUTORESET. This means the actual hardware setup of the I/O node does not match the software configuration stored in the coupler.

• Physical I/O module arrangement does not match the current software configuration
• I/O modules were added, removed, or reordered without updating the coupler's configuration

Klikk på steg for å spore fremgangen.

1. 1

   Adapt the configuration in the engineering software to precisely match the physically connected I/O module arrangement.

2. 2

   Load the updated configuration onto the coupler.

3. 3

   Cycle the supply voltage of the coupler (off then on again) to restart the device and apply the new configuration.