Option DPRAM Err

Hva betyr CPF23 ?

An option board is not correctly connected to the control board or an option board that is not made for the Drive is attached. This indicates a physical connection issue or hardware mismatch, risking improper communication or drive malfunction.

• Option board is not fully seated or improperly aligned within the drive's dedicated option slot.
• Incompatible option board model installed that is not designed for the specific drive series.
• Bent or damaged connector pins on either the option board or the drive's internal receiving slot.
• Debris or foreign material inside the option board slot preventing full insertion or electrical contact.
• Internal hardware fault on the drive's control board preventing correct recognition of the option board.

Klikk på steg for å spore fremgangen.

1. 1

   Power down the drive, remove the option board, and carefully re-insert it ensuring it is fully and correctly seated.

2. 2

   Verify the part number of the installed option board against the drive's manual for compatibility with the specific model.

3. 3

   Inspect the connector pins on both the option board and the drive's slot for any signs of bending, damage, or contamination.

4. 4

   Clean the option board connector and the drive's slot using compressed air or a non-conductive cleaner.

5. 5

   Test the option board slot with a known-good, compatible option board to isolate whether the fault is with the board or the drive slot.