TOO MANY DIGIT

Was bedeutet PS0003 ?

This alarm is issued when a value specified for an M, S, T, or B code exceeds the allowable number of digits. The maximum allowed digits are configured by parameters 3030, 3031, 3032, and 3033. For the B code, the ability to specify a decimal point, which affects the digit count, is controlled by bit 0 (AUP) of parameter No. 3450.

• Input value for parameter 'TOO MANY DIGIT' exceeds allowed limit.
• Data entry error for a numeric parameter.
• Incorrectly formatted input for a digital parameter.
• Validation failure for a string-based parameter.

Klicken Sie auf Schritte, um Ihren Fortschritt zu verfolgen.

1. 1

   Check parameter 3030 (Allowable number of digits for the M code) — verify it is set appropriately for the specified M code.

2. 2

   Check parameter 3031 (Allowable number of digits for the S code) — verify it is set appropriately for the specified S code.

3. 3

   Check parameter 3032 (Allowable number of digits for the T code) — verify it is set appropriately for the specified T code.

4. 4

   Check parameter 3033 (Allowable number of digits for the B code) — verify it is set appropriately for the specified B code.

5. 5

   For B code, check bit 0 (AUP) of parameter No. 3450 — confirm if decimal point specification is enabled (set to 1).

6. 6

   Review the NC program for the M, S, T, or B code causing the alarm — ensure the specified value does not exceed the allowed number of digits defined by parameters 3030-3033.