Default configuration

What does 8 mean?

The drive is stuck in its default configuration state during boot-up, rather than progressing to an operational state. While a normal temporary boot state, persisting in this state indicates an underlying hardware or configuration problem, potentially preventing the drive from enabling or communicating.

• Corrupted non-volatile memory (NVRAM) where drive configuration parameters are stored, causing it to revert to factory defaults.
• Failure to load parameters from an external memory device (e.g., SD card) or a connected PC during boot.
• Firmware incompatibility issues after an update, preventing parameters from being correctly interpreted or applied.
• A fault during the power-up sequence that prevents the drive from loading custom parameters.
• Incorrect setting of a critical boot parameter (e.g., Parameter P0-00 for restore defaults) preventing normal startup.

Click steps to track your progress.

1. 1

   Connect to the drive using commissioning software (e.g., Mint Workbench) and attempt to upload the drive configuration file. If successful, save the configuration.

2. 2

   Perform a factory reset of the drive (e.g., using Parameter P0-00 or a specific HMI sequence) to clear any corrupted settings.

3. 3

   Re-download a known good configuration file to the drive from a backup.

4. 4

   Verify the firmware version matches the installed hardware and is compatible with the configuration file being used. If a recent firmware update occurred, roll back or re-flash.

5. 5

   Check the status of any external memory cards (e.g., SD card) if used for parameter storage; ensure it's not corrupt and correctly inserted.