SYNCHRONIZE ADJUST MODE

What does DS0003 mean?

This Fanuc Series 0i-D/0i Mate-D alarm indicates that the system is currently in the synchronize adjust mode. This is typically an operational status rather than a fault, meaning the machine is in a special mode for setup or calibration.

• The machine was intentionally put into 'Synchronize Adjust Mode' for maintenance or setup purposes.
• Operator inadvertently entered the 'Synchronize Adjust Mode' without intending to.
• A sequence error or parameter setting caused the system to enter this mode unexpectedly.

Click steps to track your progress.

1. 1

   Verify if the machine was intentionally placed into 'Synchronize Adjust Mode' for maintenance or setup procedures.

2. 2

   Locate the control panel switch or software function used to enter and exit 'Synchronize Adjust Mode' and exit it.

3. 3

   If unable to exit the mode, check relevant system parameters or diagnostic screens for status indications.

4. 4

   Consult the machine's operation manual for the specific procedure to properly enter and exit this mode.

5. 5

   Ensure no active NC program or PMC ladder logic is inadvertently commanding the system into this mode.