Indramat · CLM01.3-M Flying Cutoff Control
Switching back from a communication phase did not result in a switch to phase 0, indicating a malfunction in the SERCOS master module of the controller connected to the Indramat DIAX04 SSE-03VRS drive.
Click steps to track your progress.
Verify the SERCOS communication configuration parameters in the master controller for any incorrect or conflicting settings.
Check the status and diagnostic LEDs on the SERCOS master module for specific error indications that might point to its internal state.
Ensure the master controller's firmware is up-to-date and compatible with the Indramat DIAX04 SSE-03VRS drive controllers.
If possible, attempt to reinitialize the SERCOS communication ring from the master controller's interface.
If the issue persists, the SERCOS master module itself may be defective and require further investigation or replacement by the control system manufacturer.