Drive system not ready for operation

¿Qué significa E2810 ?

The drive system is not in a ready state to accept commands or operate the motor. This can be due to pending errors, incomplete initialization, or unfulfilled safety conditions.

• One or more prerequisite conditions for operation (e.g., power-on, safety circuit closed, homing) are not met.
• Internal errors or warnings within the drive controller preventing readiness.
• Communication issues with the master controller (PLC) preventing the ready signal.
• Incorrect drive configuration or parameter settings.

Haga clic en los pasos para seguir su progreso.

1. 1

   Check for any other active fault codes or warnings that might be preventing the drive from achieving readiness.

2. 2

   Verify that all safety circuits (e.g., Emergency Stop, Safe Torque Off) are closed and conditions are met.

3. 3

   Check the status of the master communication (fieldbus) and ensure the drive is receiving valid commands.

4. 4

   Cycle power to the drive controller to force a complete re-initialization.