ILLEGAL COMMAND IN FLEXIBLE PATH AXIS ASSIGNMENT

What does DS0080 mean?

This alarm occurs during flexible path axis assignment in direct assign mode if an axis removal command fails to execute. This specific behavior is enabled when parameter 11563 bit #3 (WUA) is set to 0, which prevents the system from waiting for the axis removal operation to complete.

1. 1

   Check parameter 11563 bit #3 (WUA). If it is set to 0, the system will not wait for axis removal execution, leading to this alarm if the command cannot be immediately completed.

2. 2

   If it is acceptable for the system to wait for axis removal, set parameter 11563 bit #3 (WUA) to 1 to potentially prevent this alarm.

3. 3

   Investigate the specific conditions or state of the axis that prevented the removal command from executing successfully in flexible path axis assignment direct assign mode.