Spindle Control Initialization Not Terminated (15i)

Hva betyr SP0970 ?

Spindle control initialization for Series 15i was not terminated. This indicates that the spindle system did not complete its startup sequence successfully.

• The spindle control initialization process did not complete successfully.
• A critical parameter for spindle control was not set during initialization.
• The system failed to verify the readiness of the spindle drive.
• An internal error during the spindle power-up sequence.

Klikk på steg for å spore fremgangen.

1. 1

   Ensure parameter P1-01 is set to the correct spindle number.

2. 2

   Verify that the spindle drive power is correctly applied (terminal R/S/T for main power).

3. 3

   Check the spindle amplifier's status code for any initialization-related faults.

4. 4

   Execute the spindle initialization sequence again, observing all intermediate steps.